back back to FAQs
KD-MSW8x4Pro
On the MSW8x4pro’s, when I come in both RGBHV and component I don’t see my RGBHV signal.What are the RS-232 commands for ramping volume up and down.
Q: On the MSW8x4pro’s, when I come in both RGBHV and component I don’t see my RGBHV signal.
A:

The KD-MSW8x4pro comes available in two modes, RGBHV mode and component mode. The unit is set as default in component, so any source coming in RGBHV will not be seen or the picture will look very bad. Therefore, mode has to be changed and cannot be viewed at the same time.

Q: What are the RS-232 commands for ramping volume up and down.
A:

The RS-232 commands for a single MSW8x4Pro switch is as follows; ccVx++ to ramp volume up, ccVx-- to ramp down. X refers to the outputs 1-4.